Drive-In Wheelchair Ramp - Two-Part Folding Threshold Ramp, 272kg

Regular price
$649.00
Sale price
$649.00
Regular price
$800.00
Sold out
Unit price
Quantity must be 1 or more

Get Over the Step Without Getting Out of Your Chair

A single step should not decide where you can go. Our Drive-In Wheelchair Ramp is a portable, two-part folding ramp that turns a doorway threshold, a low kerb, or a shallow step into a smooth roll-through. Set it down, drive straight over it, fold it away. That is the whole job.

A Portable Wheelchair Ramp That Goes Where You Do

Made from strong, lightweight aluminium with a non-slip surface, this folding mobility ramp gives you stability underfoot and enough grip to stay confident in the wet. It suits both manual and electric wheelchairs as well as mobility scooters, and at 12.8kg for the shorter size it is light enough to carry to wherever the step is. Easy to set up, easy to pack away, easy to store.

Two-Part Folding Design with Adjustable Feet

The two-part folding design lets you go up and over the threshold in one continuous movement, with no lip to catch a castor. The adjustable feet let you set the ramp accurately to the height of your step, up to a maximum rise of 15cm, so it sits level and stays put instead of rocking under load.

Practical and Weatherproof

When not in use, the fold-up tail simply flips back onto the ramp so you can close the door over it. This threshold wheelchair ramp can be left outside, and its robust, weather-proof construction means it will handle being a permanent fixture at a back door or a shed entrance.

Which Size Do I Need?

Both sizes are 76.2cm wide, carry a safe working load of 272kg, and use the same adjustable feet with a maximum rise of 15cm. The only thing that changes is length, and length is what sets the gradient you will be pushing up.

  • 127cm (RIHT10122): at the full 15cm rise this gives roughly a 1:8 gradient. Suits assisted pushing and most powerchairs. At 12.8kg it is the easier of the two to move around and reposition single-handed.
  • 170cm (RIHT10124): at the same 15cm rise this gives roughly a 1:11 gradient, which is noticeably easier to self-propel and much safer to descend under control. Choose this one if the user pushes themselves, or if your rise is at the upper end of the range.

This ramp handles rises up to 15cm. If your step is higher than that, the adjustable feet will not reach it and this is not the right ramp for you. That includes vehicle load floors and boot lips, which sit far above 15cm on almost every vehicle. Measure your rise first, and if it comes in over 15cm, contact us with the number and we will point you to a ramp that suits.

How to Measure Before You Buy

  1. Measure the rise, not the step face. Rest a straight edge or spirit level on the top surface you are rolling onto, hold it out level, and measure straight down to the ground with a tape measure. That vertical drop is your rise. The most common mistake is running the tape along the sloped face of the step instead of straight down.
  2. Measure where the ramp will actually sit. Ground that falls away from the step adds to the rise. Take the measurement at the spot the ramp foot will land, not at the highest point of the ground.
  3. Measure the chair or scooter at its widest point, usually the wheel arches or armrests rather than the seat, and allow clearance inside the 76.2cm ramp width.
  4. Add up the total weight going up the ramp: user, plus chair or scooter, plus anything carried. Compare that against the 272kg safe working load with a margin, not right at the limit.
  5. Check where it will be stored if the ramp is going to travel with you, particularly for the 170cm version.

Match your measurements against the table below. If you fall between the two sizes, size up: the longer ramp is always the gentler gradient.

Technical Details

Both ramps are 76.2cm wide, rated to a safe working load of 272kg, adjust to a maximum rise of 15cm, and are covered by a 1-year warranty.

Drive-in wheelchair ramp sizes, weights and gradients
SKU Ramp length Ramp weight Gradient at 15cm rise
RIHT10122 127cm 12.8kg 1:8
RIHT10124 170cm 17.1kg 1:11

Gradient figures are calculated from the ramp length against the 15cm maximum rise and are provided as a guide. Safe working load is the combined weight of user, wheelchair or scooter, and anything carried.

Shipping and Returns

This item is a special-order product supplied direct from our manufacturer. Final sale: no change-of-mind returns. Please measure using the guide above and check against the table before ordering. If you are unsure which size suits your setup, contact us before you buy and we will help you work it out.

Your rights under the Australian Consumer Law are unaffected. If your order arrives faulty, damaged, or not as described, we will replace or refund it.

Stop planning your day around one step. Choose your size and add it to your cart today.

Go to full site